Are your prices making money? Run the free shop rate check
Door sections, hinges, tracks, and rollers create pinch points that can sever or crush fingers
Sectional doors have multiple pinch points where sections meet at the hinges. As the door moves, the gap between sections opens and closes with enough force to amputate fingers. Rollers entering the track radius, cable drums winding, and the gap between the door edge and jamb are all additional pinch zones. This is one of the most frequent injury types in the overhead door industry.
Never place fingers between door sections
Keep hands and fingers clear of the joints between sections at all times, whether the door is moving or stationary. A door that shifts even slightly can close the gap and cause injury.
Disconnect and secure the door before hinge or roller work
Disconnect the operator and clamp the door in position before removing or installing hinges and rollers. A section that shifts during work can create unexpected pinch points.
Use pinch-resistant hinges where possible
Modern tamper-resistant hinges are designed to reduce the gap between sections and minimize pinch hazards. Recommend these during installations and retrofits.
Keep hands clear of the track and cable system
Do not reach into the track or near the cable drums while the door is in motion. Keep your hands on designated handles or grip points when manually operating the door.
Wear proper gloves
Wear snug-fitting, heavy-duty work gloves to protect against minor pinches and cuts. However, do not rely on gloves as primary protection. They cannot prevent crush or amputation injuries.